Service manual

OPERATOR CAB (Cont’d)

Lowering The Operator Cab

NOTE: Make sure the seat bar is fully raised or

lowered when lowering the cab.

Pull down on the bottom of the operator cab until it stops

at the latching mechanism.

Release the latching mechanism (Item 1) [A] and pull the

cab all the way down.

Install the plate and nut (Item 1) [B] (both sides).

Tighten the nuts to 40–50 ft.–lbs. (54–68 Nm) torque [B].

Emergency Exit

The front opening on the operator cab and rear window

provide exits.

To exit through the rear window, use the following

procedure:

Pull on the tag on the top of the rear window to remove the

rubber cord [C].

Push the rear window out of the rear of the operator cab.

Exit through the rear of the operator cab [D].

CD–15124

P–00660

P–00383

–1–10–

853, 853H Loader

Service Manual

CD–15126