Service manual

FAN DRIVE TENSION PULLEY
Removal And Installation
Remove the fan drive belt.
Remove the idler pulley bolt (Item 1) [A].
Remove the spacers, bolt and washers from the arm [B].
Installation: Put a small amount of grease around the
outside edge on the grease rings (Item 1) [B] between
ring and bearing.
Remove the bolt (Item 1) [C], spring and arm.
Check all parts for damage or wear. Replace the parts as
needed.
Installation: Grease the pivot bolt (Item 1) [D] thrust
washer (Item 2) [D] and O–rings (Item 3) [D].
A
P–04954
1
D
N–00303
3
3
2
1
C
P–04955
1
–7–12–
853, 853H Loader
Service Manual
B
P–04956
P–00581
1