Service manual

RADIATOR
Removal And Installation
Open the rear door.
Remove the rear grill. (See Page 5–1.)
Remove the oil cooler. (See Page 3–1.)
Remove the engine muffler. (See Page 7–7.)
Loosen the radiator cap.
Connect a hose to the engine block drain (Item 1) [A].
Open the block drain (Item 1) [A] and drain coolant into
a container.
NOTE: Early S/N Loaders use a hex plug in this
location for the drain.
Disconnect the hose (Item 1) [B].
Disconnect the hose (Item 1) [C].
Remove the radiator mounting bolts (Item 1) [D] (both
sides).
Installation: Mix coolant in a separate container. (See
Specifications for correct capacity Page 9–1.)
Propylene Glycol
Add premixed coolant: 47% water and 53% propylene
glycol to the recovery tank if the coolant level is low.
One gallon and one pint of propylene glycol mixed with
one gallon of water is the correct mixture of coolant to
provide a –34°F (–37°C) freeze protection.
Use a refractometer to check the condition of propylene
glycol in your cooling system.
Ethylene Glycol
Add premixed coolant: 50% water and 50% ethylene
glycol to the recovery tank if the coolant level is low.
A
P–04896
1
C
P–04895
1
D
P–04893
1
–7–10–
853, 853H Loader
Service Manual
B
P–04894
1