Service manual

LIFT ARM SUPPORT DEVICE (Cont’d)
Disengaging The Lift Arm Support Device
Remove the pin from the lift arm support device.
Connect the spring (Item 1) [A] from the lift arm support
device to the bracket below the lift arms.
With the operator in the seat, seat belt fastened and seat
bar lowered, start the engine.
Raise the lift arms a small amount and the spring will lift
the support device off the lift cylinder rod.
Lower the lift arms. Stop the engine.
Raise the seat bar and move pedals until both pedals
lock.
Disconnect the spring from the bracket.
Raise the support device into storage position and insert
pin through lift arm support device and bracket [B].
Connect spring to pin.
A
P–01542
1
–1–8–
853, 853H Loader
Service Manual
B
P–02133