Service manual

STARTER
Checking The Starter
The key switch must be in the OFF position.
The battery must be at full charge.
The cable connections on the battery must be clean and
tight.
Connect a jumper wire between S terminal and BAT
terminal [A].
If the starter turns but does not turn the engine, the starter
drive has a defect.
Connect a jumper wire between the M terminal and the
BAT terminal [B].
If the starter turns, the defect is in the solenoid.
If the starter does not turn, the starter is defective.
A
A–01992
Cranking
Bat
S
M
Motor
Jumper Wire
B
A–01991
Cranking
Motor
Bat
S
M
Jumper Wire
–6–16–
853, 853H Loader
Service Manual