Service manual

BATTERY (Cont’d)
Using A Booster Battery (Jump Starting)
If it is necessary to use a booster battery to start the
engine, BE CAREFUL! There must be one person in the
operator’s seat and one person to connect and
disconnect the battery cables.
The ignition must be in the OFF position. The booster
battery to be used must be 12 volt.
Connect the end of the first cable (Item 1) [A] to the
positive (+) terminal of the booster battery. Connect the
other end of the same cable (Item 2) [A] to the positive
terminal on the starter solenoid.
Connect the end of the second cable (Item 3) [A] to the
negative (–) terminal of the booster battery. Connect the
other end of the same cable (Item 4) [A] to the engine.
Keep cables away from moving parts. Start the engine.
(Also see Cold Temperature Starting Condition,
Operation & Maintenance Manual.)
After the engine has started, remove the ground (–) cable
(Item 4) [A] first. Remove the cable from the positive
terminal on the starter solenoid.
W–2065–1296
Batteries contain acid which burns eyes and
skin on contact. Wear goggles, protective
clothing and rubber gloves to keep acid off
body.
In case of acid contact, wash immediately with
water. In case of eye contact get prompt medical
attention and wash eye with clean, cool water
for at least 15 minutes.
If electrolyte is taken internally drink large
quantities of water or milk. DO NOT induce
vomiting. Get prompt medical attention.
Keep arcs, sparks, flames and lighted tobacco
away from batteries. When jumping from
booster battery make final connection
(negative) at engine frame.
Do not jump start or charge a frozen or damaged
battery. Warm battery to 60
o
F. (16
o
C.) before
connecting to a charger. Unplug charger before
connecting or disconnecting cables to battery.
Never lean over battery while boosting, testing
or charging.
Battery gas can explode and cause serious
injury.
W–2066–1296
Damage to the alternator can occur if:
I–2023–1285
• Engine is operated with battery cables
disconnected.
• Battery cables are connected when using a
fast charger or when welding on the loader.
(Remove both cables from the battery.)
• Extra battery cables (booster cables) are
connected wrong.
A
CD–15009
CD–15010
4
2
3
1
853, 853H Loader
–6–9– Service Manual