Service manual

A
P–05041
1
REAR DOOR
Removal And Installation
Open the rear door, disconnect the wiring harness
connector (Item 1) [A].
Remove the nuts (Item 2) [A] from the pivot bolts.
Installation: Tighten the bolts and nuts to 25–28 ft.–lbs.
(34–38 Nm) torque.
Connect a 1/4 inch chain to the rear door using two bolts
(Item 1) [B].
Inside the rear door, secure the chain with washers and
nuts.
Connect a chain hoist to the chain.
Remove the rear door pivot bolts.
Lift the rear door away from the loader frame and put the
door flat on the floor.
B
P–05042
2
1
2
853, 853H Loader
–5–13– Service Manual