Service manual

BOB–TACH (Cont’d)

Bob–Tach Lever And Wedge (Cont’d)

Using a punch and hammer, remove the roll pin (Item 1)

[A] from the Bob–Tach wedge and spring, bolt and clevis

assembly.

Remove the spring, bolt and clevis assembly (Item 1) [B].

Remove the wedge (Item 2) [B] from the Bob–Tach

frame.

Always replace bent or broken wedges.

If the bolt (Item 1) [C], handle pivot (Item 2) [C], spring

(Item 3) [C] or clevis (Item 4) [C] are damaged, put the

assembly in the vise. Loosen and remove the bolt (Item

1) [C] with a 5/16 inch allen wrench.

Replace the worn or damaged parts as needed.

Reverse the removal procedure to install the Bob–Tach

Lever and Wedge.

Bob–Tach Stops

Remove and replace the Bob–Tach stop (Item 1) [D]

(both sides) if worn or damaged.

NOTE: The Bob–Tach stop (Item 1) [D] must contact

the lift arm at the same time the tilt cylinder

reaches full extension. Use available shims

to adjust the Bob–Tach stop and tilt cylinder

sequence as closely as possible.

P–03925

P–03929

P–03914

–5–10–

853, 853H Loader

Service Manual

P–03926