Service manual

BOB–TACH (Cont’d)
Removal And Installation (Cont’d)
Install the Bob–Tach mounting bolt (Item 1) [A] into the
pivot pin (Item 2) [A]. Remove the pivot pin from the
Bob–Tach frame.
Check for wear and damage. Replace the pivot pins as
needed.
Installation: Push the pivot pin (Item 2) [A] into the
Bob–Tach frame. Position the end of the pin flush with the
end of the Bob–Tach bushing (Item 3) [A].
Reverse the removal procedure to install the Bob–Tach.
Bob–Tach Lever And Wedge
Use the following procedure to remove and install the
Bob–Tach lever (Item 1) [B], spring and wedge:
Remove the lever mounting bolt and nut (Item 1) [C],
washer (Item 2) [C] and spring (Item 3) [C].
Installation: Tighten the nut to 25–28 ft.–lbs. (34–38 Nm)
torque.
Remove the Bob–Tach lever (Item 1) [D].
A
P–03912
1
2
3
C
P–03928
1
2
3
D
P–03924
1
853, 853H Loader
–5–9– Service Manual
B
P–03930
1