Service manual

BOB–TACH
Removal And Installation
Tilt the Bob–Tach forward, so it is parallel to the floor. Put
blocks approximately 3 inches thick under each side of
the Bob–Tach (Item 1) [A]. Lower the Bob–Tach onto the
blocks [A].
Remove the retainer bolt (Item 1) [B] from the pivot pin.
Installation: Tighten the retainer bolt to 18–20 ft.–lbs.
(24–27 Nm) torque.
Remove the grease fitting from the pivot pin (Item 1) [C].
Remove the rod end pivot pin (Item 1) [C].
Remove the tilt cylinder rod end.
Remove the seals (Item 1) [D].
A
CD–15075
1
C
P–03915
1
D
P–03911
1
853, 853H Loader
–5–7– Service Manual
B
P–04601
1