Service manual

OPERATOR CAB (Cont’d)

Removal And Installation (Cont’d)

Remove the nut (Item 1) [A] from the pivot bolt (both

sides).

Installation: Tighten the pivot bolt and nut to 25–35

ft.–lbs. (34–47 Nm) torque.

Remove the pivot bolt (both sides).

Move the operator cab forward a small amount for

clearance at the pivot mounting brackets [B].

Install the pivot bolt, washer (one on each side) and nut

(Item 1) [B] (both sides).

Install the sling under the pivot bolt and pivot of the

operator cab [B].

Connect the slings to a chain hoist and remove the

operator cab from the loader [C].

P–05050

P–05048

–5–6–

853, 853H Loader

Service Manual

P–05049