Service manual

OPERATOR CAB
Removal And Installation
Remove the cab nut and holddown plate (Item 1) [A] (both
sides).
Installation: Tighten the nut to 40–50 ft.–lbs. (54–68 Nm)
torque.
Remove both gas cylinders (Page 5–7).
Disconnect the wiring harness connectors (Item 1) [B].
Disconnect the ground wire (Item 2) [B].
Connect a chain hoist to the operator cab grab handles
and lower the operator cab when the gas cylinders are
disconnected [C].
Revised June 97
A
CD–15125
1
B
P–00883
1
2
1
C
P–05051
853, 853H Loader
–5–5– Service Manual