Service manual

OPERATOR CAB GAS CYLINDER
Removal And Installation
Cylinder contains high pressure gas. Do not
open. Opening cylinder can release rod and
cause injury or death.
W–2113–0288
Remove the operator cab stop (Item 1) [A] (both sides).
NOTE: Be careful not to break the rear window when
the cab is raised after the cab stops are
removed.
Raise the operator cab (See Page 1–1).
Remove the nuts (Item 1) [B] from the gas cylinder
mounting bracket.
Move the mounting bracket to relieve any remaining
tension on the gas cylinder [C].
Remove the cotter pin (Item 1) [D] from the top pivot pin.
Remove the pivot pin and bushing from the gas cylinder.
Remove the gas cylinder.
Never work on a machine with the lift arms up
unless the lift arms are secured by an approved
lift arm support device. Failure to use an
approved lift arm support device can allow the
lift arms or attachment to fall and cause injury
or death.
W–2059–0598
C
CD–15016
D
CD–15173
1
A
CD–15014
1
853, 853H Loader
–5–3– Service Manual
B
CD–15015
1