Service manual

REDUCTION GEARCASE
Reduction Gearcase Seal
The tool listed will be needed to do the following
procedure:
MEL1047 – Seal Installation Tool
Lift and block the loader. (See Page 1–1.)
Remove the hydrostatic motor. (See Page 3–1.)
Drill a hole into the reduction gearcase seal [A].
Install a slide hammer with a screw tip end into the seal
[B].
Remove the reduction gearcase seal.
Install the new quad ring on the installation tool.
Install the backup washer.
Use a hammer, hit the installation tool until the quad ring
is fully seated [C].
A
P–04795
C
P–04806
853, 853H Loader
–4–15– Service Manual
B
P–04798