Service manual

AXLE, BEARING AND SPROCKET (Cont’d)
Removal And Installation (Cont’d)
Use the bearing cup installation tools (Item 1) [A] & (Item
1) [B].
Put the inner cup (Item 2) [A] in the axle tube.
Install the long treaded rod (Item 2) [B] into the axle tube
and through the installation tool (Item 1) [A].
Install the nut (Item 3) [A].
Install the installation tool (Item 1) [B] on the threaded
rod. Install the nut.
Hold the inside nut (Item 3) [A] with a wrench and tighten
the outside nut [B].
Tighten the nut until the bearing cup is installed inside the
axle tube.
Remove the installation tools and threaded rod.
To install the outer bearing cup, install the bearing cup tool
on the driver handle.
Install the bearing cup into the axle tube, and put the tool
into the bearing cup.
Hit the driver handle with a hammer until the bearing cup
is installed inside the axle tube [C].
A
P–04807
1
3
2
C
P–04813
–4–14–
853, 853H Loader
Service Manual
B
P–04811
1
2