Service manual

AXLE, BEARINGS AND SPROCKET (Cont’d)
Removal And Installation (Cont’d)
Use the tools provided in the (MEL1202B) Axle Bearing
Service Set for bearing cup removal and installation. A
slide hammer is also needed.
Use the long rod and bearing cup tool to remove the inner
bearing cup [A].
To remove the outer bearing cup, install a bearing cup tool
on the slide hammer.
Leave the bearing cup tool loose until the tool is installed
inside the tube [B].
Pull the tool against the bearing cup and tighten the nut.
Use the slide hammer and remove the bearing cup from
the axle tube [C].
A
P–04812
C
P–04816
853, 853H Loader
–4–13– Service Manual
B
P–04818