Service manual

AXLE, BEARINGS AND SPROCKET (Cont’d)

Removal And Installation (Cont’d)

Push the axle out until the ram is at the end of the stroke.

Add a spacer and push the axle out again. Repeat this

procedure until the axle is out of the sprocket.

Remove the drive chain from the sprocket.

Remove the sprocket (Item 1) [A] and inner bearing (Item

2) [A].

Installation: Pack the inner and outer bearing with

grease before installing them.

A bearing puller (Item 1) [B] is needed to do the following

procedure:

Be sure the bearing puller makes good contact with the

inner race and press the bearing off the mounting surface

of the axle [B].

NOTE: Hold onto the axle during removal as it will

slide freely after the bearing is removed from

the mounting surface.

Press the splined end of the axle free from the bearing

[C].

Installation: Put the spline end of the axle shaft into the

bearing and press the bearing onto the axle.

NOTE: Hold onto the axle during installation as it

will slide freely after the bearing is pressed

over the splined end of the shaft.

Put a piece of tubing (Item 1) [D] that contacts inner race

of the bearing only.

Press the bearing onto the mounting surface until the

bearing is fully seated [D].

P–04808

P–04171

P–04175

–4–12–

853, 853H Loader

Service Manual

P–04170