Service manual

AXLE SEAL (Cont’d)
Removal And Installation (Cont’d)
Install a slide hammer (Item 1) [A] with a screw tip end into
the axle seal.
Remove the axle seal.
The tool listed will be needed to do the following
procedure:
MEL1407 – Seal Installation Tool
If the axle is damaged or worn, an axle repair sleeve kit
is available from Melroe Parts Sales in Chicago.
NOTE: If a new wear ring is being installed with new
seal, put LOCTITE sealant on the inside
diameter of the wear ring.
Place the taper on the wear ring so it faces the outside [B].
Place the seal with the lip facing in [B].
Use a hammer, install the new axle seal until the tool is
flush with the edge of the axle tube [C].
A
P–04817
1
C
P–04814
–4–10–
853, 853H Loader
Service Manual
B
B–13493
Taper