Service manual

AXLE SEAL
Removal And Installation
Lift and block the loader. (See Page 1–1.)
Remove the tire/wheel assembly.
Installation: Tighten the wheel nuts to 105–115 ft.–lbs.
(142–155 Nm) torque.
Remove the bolts (Item 1) [A] and plate.
Installation: Tighten the bolts to 175–190 ft.–lbs.
(240–260 Nm) torque.
Remove the two wheel studs (Item 2) [A] across from
each other.
Install puller (Item 1) [B] on the wheel hub.
NEVER STAND IN–LINE OF THE HUB WHEN
REMOVING A HUB FROM AN AXLE. The hub
has a tapered fit on the axle end and can come
off the axle with great force and cause serious
injury.
Remove the hub from the axle.
Remove the key (Item 1) [C] from the axle.
Drill a hole into the axle seal [D].
W–2186–0395
A
P–04850
2
1
2
C
P–04848
1
D
P–04815
853, 853H Loader
–4–9– Service Manual
B
P–04849
1