Service manual

PARKING BRAKE (Cont’d)
Brake Block And Pads (Cont’d)
Remove the brake block [A].
Installation: Clean and dry the brake block. Put a bead
of R.T.V. sealant on the brake block.
Remove the shaft from the brake block [B].
Installation: Always install a new O–ring (Item 1) [B]
when the shaft is installed. Make sure the shaft rotates in
the cover.
Check the parts for wear or damage and replace as
needed.
Brake Discs
To remove the parking brake discs [C], use the following
procedure:
MEL1242 – Port–a–Power tool is needed for the removal
procedure.
Lift and block the loader. (See Page 1–1.)
Raise the operator cab. (See Page 1–1.)
Remove the front panel/steering levers assembly. (See
Page 3–1.)
Remove the parking brake/cover assembly. (See Page
4–4.)
Remove the front and rear covers. (See Page 4–8.)
Remove the fluid from the chaincase. (See page 4–27.)
Remove the hydrostatic motor. (See Page 3–1.)
Remove the rear and front axles. (See Page 4–11.)
Disconnect the rear and front drive chains.
Move the gearcase away from the chaincase to slide the
brake discs off.
Never work on a machine with the lift arms up
unless the lift arms are secured by an approved
lift arm support device. Failure to use an
approved lift arm support device can allow the
lift arms or attachment to fall and cause injury
or death.
W–2059–0598
A
CD–11024
C
CD–11026
853, 853H Loader
–4–7– Service Manual
B
CD–11025
1