Service manual

PARKING BRAKE (Cont’d)
Removal And Installation (Cont’d)
Remove the nuts from the brake linkage rod [A].
Disconnect the brake lever spring and remove the spring
(Item 1) [B], retainer plate (Item 2) [B] and bolt (Item 3)
[B].
Installation: Tighten the brake lever bolt to 65–70 ft.–lbs.
(88–95 Nm) torque.
Remove the cover bolts [B].
Remove the cover/brake block assembly [C].
Installation: Clean and dry the cover. Clean the surface
on the chaincase where the cover sets.
Install a new gasket on the cover/brake block assembly.
A
CD–11014
C
CD–11019
853, 853H Loader
–4–5– Service Manual
B
CD–11018
3
2
1