Service manual

PARKING BRAKE PEDAL
Adjustment
When the parking brake is in good condition and adjusted
correctly, it will keep the loader from moving when the
steering levers are moved.
Raise the operator cab. (See Page 1–1.)
Loosen the lock nut and turn the nut (Item 1) [A] to adjust
the parking brake linkage.
With the brake released, lift the pedal to remove linkage
end play.
Adjust the pedal so there is 2.0 inch (51 mm) from the top
of the pedal to the top of the chaincase cover [B].
Tighten the lock nut against the adjustment nut when the
adjustment is correct.
NOTE: If the correct brake adjustment can not be
obtained by turning the nut, the brake lever
must be adjusted using the following
procedure.
Loosen the nut (Item 1) [A].
Disconnect the spring (Item 1) [C] from the brake lever.
Loosen the bolt (Item 2) [C] on the brake lever. Do not
remove the bolt.
Use a pry bar and hammer, pry up on the lever and hit the
bolt with a hammer until the brake lever is loose [D].
Remove the bolt and brake lever.
Turn the brake block shaft counterclockwise until the
brake pads make contact with the brake discs.
Install the brake lever. Install the bolt and tighten to 65–70
ft.–lbs. (88–95 Nm) torque.
Re–adjust the parking brake.
B
B–13820
Lift release pedal to
remove linkage end play
2.0 “
(51 mm)
A
CD–11014
1
D
CD–11016
853, 853H Loader
–4–3– Service Manual
C
CD–11015
2
1