Service manual

FIXED TENSIONER PULLEY (Cont’d)

Assembly

NOTE: The bearings, cups and spacers are a

matched set and must be replaced as a unit.

If the spacer is replaced, compress the new spacer and

install into the pulley [A].

Use a driver tool (1–5/16’’ diameter) and push the spacer

into the machined groove [B].

Install the bearing cup using the driver tool (both sides)

[C].

NOTE: The seal side of the pulley hub has the larger

I.D. diameter.

Install the taper roller bearing to the pulley (seal side) [D].

CD–12641

CD–12643

CD–12644

–3–36–

853, 853H Loader

Service Manual

CD–12642