Service manual

SPRING LOADED DRIVE BELT TENSIONER PULLEY

(Cont’d)

Assembly (Cont’d)

Install the first retainer washer (Item 1) [A] and spring

washer (Item 2) [A] over the roll pins.

Install the second retainer washer (Item 1) [B], the

washer (Item 2) [B] and the bolt (Item 3) [B]. Tighten the

bolt to 28–32 ft.–lbs. (38–45 Nm) torque.

Fill the grease cap 1/4 full (approximately 1/2–3/4 oz.) of

grease.

Press the grease cap (Item 1) [C] onto the pulley

assembly (Item 2) [C]. Press on the outer formed edge of

the grease cap.

NOTE: When pressing the grease cap onto the

pulley assembly, do not press down on the

arrow indicator plate. Support the hub

assembly so that it contacts only the hub and

not the arrow indicator plate.

P–08875

P–08877

853, 853H Loader

–3–31– Service Manual

P–08876