Service manual

SPRING LOADED TENSIONER PULLEY (Cont’d)
Assembly
Install the spring (Item 1) [A] on the pulley (Item 2) [A] as
shown.
Install the shaft from the bracket assembly (Item 1) [B]
into the pulley assembly (Item 2) [B] and align the spring
(Item 3) [B] over the alignment pin on the bracket.
Turn the pulley assembly over and install the two pins
(Item 1) [C] into the hub.
Install a punch as shown and turn clockwise while
applying down pressure on the pulley.
Turn until the pulley snaps down into place; this procedure
winds the spring and retains the end of the spring in
proper location [D].
A
P–08871
2
1
C
P–08873
1
D
P–08874
–3–30–
853, 853H Loader
Service Manual
B
P–08872
1
2
3