Service manual

HYDROSTATIC MOTOR (Cont’d)

Removal And Installation (Cont’d)

Remove the hydrostatic motor from the gearcase.

Installation: Replace the large O–ring (Item 1) [A] and

face seals on the motor fittings before installing the motor

Inspect and clean or replace case drain filters (Item 1) [B]

& [C] during motor repair or replacement.

NOTE: The case drain filters were added at (S/N

510125001 & Above), (S/N 510250001 &

Above) and (S/N 510370001 & Above) on the

loaders.

SEE THE COMPONENT REPAIR MANUAL FOR

HYDROSTATIC MOTORS FOR DISASSEMBLY AND

ASSEMBLY PROCEDURE.

P–00972

P–04799

–3–18–

853, 853H Loader

Service Manual

P–00969