Service manual

P–02866

STEERING LEVERS (Cont’d)

Hydrostatic Pump Neutral Adjustment (Cont’d)

3. Clamp the control lever to the neutral adjustment

bracket with a small locking pliers [A].

4. Start the engine. With the engine running at full

RPM, move the control lever forward until the

wheels just begin to move. Mark the position on the

bracket (felt tip pen) [B].

5. Move the control lever in reverse until the wheels

just begin to move. Mark this position.

6. Stop the engine.

7. Position the neutral adjustment bracket between

the two marks and tighten the holddown bolt [C].

Remove the locking pliers. Start the engine and

check in both directions to be sure the pump will

return to neutral.

8. Remove the socket from blocking the neutral spring

bracket [D].

9. Adjust the steering neutral setting. (See Page

3–12.)

P–07929

P–07931

–3–16–

853, 853H Loader

Service Manual

P–07930