Service manual

STEERING LEVERS (Cont’d)

Adjusting The Wheel RPM Left Compared To Right

Side

1. Loosen the bolts at the stop (Item 1) [A] and lower

the lever stops (both sides).

NOTE: This procedure is for MINOR adjustment in

full forward travel only. Steering neutral

setting must be correctly adjusted before

this procedure. Early S/N loaders do not have

this adjustment.

2. Start the engine.

Put jackstands under the front axles and rear

corners of the frame before running the engine

for service. Failure to use jackstands can allow

the machine to fall or move and cause injury or

death.

W–2017–0286

3. Check wheel RPM left and right side [B]. They

should be the same. If not, the stop (Item 1) [A] can

be used for MINOR adjustment. Bring the stop up

on the faster side until RPM is equal. (Tighten stop

before re–checking) tighten remaining side in down

position.

P–02875

–3–14–

853, 853H Loader

Service Manual

P–07959