Service manual

STEERING LEVERS (Cont’d)
Adjusting The Wheel RPM Forward Compared To
Reverse Travel (Cont’d)
5. Move the lever to the neutral position. Measure the
distance from the U–bolt to the lock nut [A]. Neutral
must be adjusted to 3.21 inch (82 mm) per example.
EXAMPLE:
Forward 3.66 inch (93,0 mm)
Reverse – 2.76 inch (70,0 mm)
0.90 inch (23,0 mm) Total Travel*
Divided by Two =0.45 inch (11,0 mm) Half the Travel
+2.76 inch (70,0 mm) Reverse Travel
3.21 inch (82,0 mm) Is Neutral
If adjustment is required, loosen the mounting bolts (Item
1) [B].
Moving the neutral spring bracket up will allow more
forward stroke and more forward wheel RPM. Moving it
down will allow more rearward stroke and more reverse
wheel RPM.
Use a screwdriver to move the neutral spring bracket
(Item 1) [C] down or a large pliers to move it up in its
slotted holes.
Tighten the mounting bolts on the spring bracket (Item 1)
[B].
Neutral to forward cable travel must be within 0.010 inch
(0,25 mm) left compared to right side.
Install pintle link bolts (Item 1) [D] (both sides).
NOTE: Keep the bracket vertical to be sure that the
cams make full contact in the pocket of the
detent bracket.
A
MC–01943
NEUTRAL
3.21 “
(82,0 mm)
D
P–07927
1
C
N–00302N–00301
1
1
–3–12–
853, 853H Loader
Service Manual
B
P–02875
1
CD–11204