Service manual

FRONT PANEL

Removal And Installation

Put jackstands under the front axles and rear

corners of the frame before running the engine

for service. Failure to use jackstands can allow

the machine to fall or move and cause injury or

death.

W–2017–0286

Raise the operator cab. (See Page 1–1.)

Remove the mounting bolts (Item 1) [A] from the throttle

lever.

Disconnect the linkage rod (Item 1) [B] from the throttle

lever.

Disconnect the wire harness connectors (Item 1) [C]from

the steering lever wire harness.

NOTE: The 853 without front auxiliary hydraulics

does not have electric control handle.

Remove the right side steering shock (Item 2) [D].

NOTE: Early S/N loaders do not have steering panel

braces (Item 3) [C]. The right side steering

shock is mounted inside the steering panel.

Remove the steering panel brace bolts (Item 1) [D].

NOTE: Bolts have a nut on rear side holding panel

brace.

Never work on a machine with the lift arms up

unless the lift arms are secured by an approved

lift arm support device. Failure to use an

approved lift arm support device can allow the

lift arms or attachment to fall and cause injury

or death.

W–2059–0598

P–09926

P–04737

P–09329

853, 853H Loader

–3–5– Service Manual

P–09927