Service manual

TROUBLESHOOTING
Chart
The following troubleshooting chart is provided for
assistance in locating and correcting problems which are
most common. Many of the recommended procedures
must be done by authorized Bobcat Service Personnel
only.
W–2004–1285
Check for correct function after adjustments,
repairs or service. Failure to make correct
repairs or adjustments can cause injury or
death.
No drive on one side, in one direction. 1, 2
No drive on one side in both directions. 2, 3, 4, 5
The loader does not move in a straight line. 2, 3, 5, 6, 7
The hydrostatic system is overheating. 8, 9, 10, 11
Service code HP 2 appears (Warnings, low charge pressure) or the
warning light comes ON (853 Base). 8, 11, 12, 13, 14
1. The hydrostatic pump replenishing valves not seating.
2. The steering linkage needs adjustment.
3. The hydrostatic pump has damage.
4. The final drive chains are broken.
5. The hydrostatic motor has damage.
6. The tires do not have the correct tire pressure.
7. The tires are not the same size.
8. The hydrostatic fluid is not at the correct level.
9. The oil cooler has a restriction.
10. The temperature sending switch is not operating correctly.
11. The loader is not being operated at the correct RPM.
12. The sender is defective.
13. Pump is defective or worn hydrostatics.
14. Hydraulic filter is plugged.
PROBLEM CAUSE
KEY TO CORRECT THE CAUSE
853, 853H Loader
–3–3– Service Manual