Instruction manual

42
3. Repeat Roll Test
If stroller still pulls to the left, repeat
steps 1 and 2.
SELECT SHOCK SETTING
1. Remove Children From Seats
2. Set Shock Setting To Position 2
Depress shock release knob and
simultaneously pull toward back of
stroller, sliding knob into position 2.
Knob will “snap” into place when in
correct position.
REPEAT on opposite side.
Position 1: SOFTER
CLICK
Position 2: HARDER
CLICK
NOTE: Every time stroller is folded,
stroller shocks default SOFTER position.
SETTING PARKING BRAKE
The parking brake prevents the
stroller from moving while loading
and unloading. The parking brake is
not designed as a stopping brake.
The parking brake is not designed
as a stopping brake. The brake
should not be used to slow or stop
the stroller because doing so could
cause the stroller to stop abruptly,
resulting in loss of control.
Do not park on inclines. The
parking brake is intended to park
the stroller on fl at surfaces only.
Parking on inclines may result in tip
over or runaway stroller.
To set the parking brake, press the
brake bar down into the locked
position with your foot on the red foot
pedal – making sure the locking pin
fully engages the locking disk.
LOCKED POSITION
LEFT Knob