Specification Sheet
For information on product shelf life contact BSI Customer Service at (800) 223-7699
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Employers should complete an assessment of all workplaces to determine the need for, and selection of, proper exposure
controls and protective equipment for each task performed.
Hazardous Component(s)
ACGIH TLV
OSHA PEL
AIHA WEEL
OTHER
Bisphenol A Epoxy Resin
200 ppm TWA
None
None
None
Aminoethylpiperazine
Poly-Mercaptan Resin
150 ppm TWA
None
None
None
None
None
None
None
Engineering controls: Use positive down-draft exhaust ventilation if general ventilation is
insufficient to maintain vapor concentration below established exposure
limits.
Respiratory protection: Not required for properly ventilated areas.
Eye/face protection: Safety goggles or safety glasses with side shields. Full face protection
should be used if the potential for splashing or spraying of product exists.
Skin protection: Use chemical-resistant, impervious gloves as necessary to prevent contact.
9. PHYSICAL AND CHEMICAL PROPERTIES
Physical state: Liquid
Color: Slight amber
Odor: Mild Amine
Odor threshold: N/D
pH: Alkaline
Vapor pressure: 1.17 mm hg (0.156 kPa)
Boiling point/range: >200°C (>392°F)
Melting point/ range: Not determined
Specific gravity: 0.97 / 1.15
Vapor density: N/A
Flash point: 101°C (214°F) ASTM D-56
Flammable/Explosive limits - lower: N/A
Flammable/Explosive limits - upper: N/A
Auto-ignition temperature: N/A
Evaporation rate: N/A
Solubility in water: Some
Partition coefficient (n-octanol/water): 3.8
VOC content: < 2 %; < 20 g/l (California SCAQMD Method 316B) (Estimated)
Viscosity: 10,000 to 12,000 cps..
Decomposition temperature: >200°C (>392°F)
10. STABILITY AND REACTIVITY
Stability: Material is stable under recommended storage conditions.
Hazardous reactions: Hazardous polymerization will not occur.
Hazardous decomposition
products: Material does not decompose at ambient temperatures.
Incompatible materials: Organic and mineral acids, strong oxidizers
Reactivity: Not available.
Conditions to avoid: No specific data
Item number: 203-204 Product name: Mid-Cure™
Page 3 of 5