Material Safety Data Sheet

For information on product shelf life contact BSI Customer Service at [phone]
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Employers should complete an assessment of all workplaces to determine the need for, and selection of, proper exposure
controls and protective equipment for each task performed.
Hazardous Component(s)
ACGIH TLV
OSHA PEL
AIHA WEEL
OTHER
Naphtha (Petroleum) Hydrotreated Heavy
100 ppm TWA
None
None
None
N,N Dimethyl-P-Toluidine
None
None
None
None
Engineering controls: Use positive down-draft exhaust ventilation if general ventilation is
insufficient to maintain vapor concentration below established exposure
limits.
Respiratory protection: Use NIOSH approved respirator if there is potential to exceed
exposure limit(s). Organic vapor cartridges are recommended.
Eye/face protection: Safety goggles or safety glasses with side shields. Full face protection
should be used if the potential for splashing or spraying of product exists.
Skin protection: Use oil resistant gloves and aprons as necessary to prevent contact.
9. PHYSICAL AND CHEMICAL PROPERTIES
Physical state: Liquid
Color: Colorless, Transparent
Odor: Odorless
Odor threshold: N/D
pH: Not applicable
Vapor pressure: 1.17 mm hg (0.156 kPa)
Boiling point/range: 155 °C (311°F) - 179°C (354°F)
Melting point/ range: Not determined
Specific gravity: 0.749
Vapor density: Approximately 5
Flash point: 44°C (111°F) ASTM D-56
Flammable/Explosive limits - lower: 0.7
Flammable/Explosive limits - upper: 5.6
Auto-ignition temperature: 340 °C (644°F)
Evaporation rate: 0.29
Solubility in water: Negligible
Partition coefficient (n-octanol/water): Not determined
VOC content: < 2 %; < 20 g/l (California SCAQMD Method 316B) (Estimated)
Viscosity: 1.49 cps..
Decomposition temperature: Not determined
10. STABILITY AND REACTIVITY
Stability: Material is stable under recommended storage conditions.
Hazardous reactions: Hazardous polymerization will not occur.
Hazardous decomposition
products: Material does not decompose at ambient temperatures.
Incompatible materials: Strong oxidizers
Reactivity: Not available.
Conditions to avoid: Avoid heat, sparks, open flames and other ignition sources
Item number: 151-152 Product name: Insta-Set™
Page 3 of 5