User's Manual

Marker will not turn on out of the box—

Ensure that the battery that you’re using in your new marker is a high quality alkaline 9

volt. Verify that your battery is correctly oriented (matching with the correct terminals),

and that it is making rm contact with the prongs on the circuit board. Make sure that

the wiring harness is correctly inserted into the receptacle, and that the on\off pad is

making contact with the switch on the circuit board.

Velocity is inconsistent over the chronograph—

Always check that your paintballs are of high quality, and consistent in size, as well as

using a correctly sized barrel. If this does not correct your issue, verify that your verti-

cal regulator and low pressure regulator are lubricated and that their seals are in good

condition. Replace your battery. Also, inspect the rammer orings for nicks and that it is

properly lubricated.

Marker chops paint—

Always check that your paintballs are of high quality, and consistent in size, as well as

using a correctly sized barrel. If this does not correct your issue, verify that your verti-

cal regulator and low pressure regulator are lubricated and that their seals are in good

condition—drop off and regulator inconsistency are almost always the culprit in paint

breakage. Ensure that your detents and bolt face are in good condition, and there is

nothing in the breech of the marker. Reset your board settings to factory, and use a

force-fed loader.

Marker does not air up after tank is connected—

Verify that the pin valve on your tank is outputting pressure to the regulator—some

tanks will not work properly with certain ASAs. Attempt airing up the marker with anoth-

er tank to see if this remedies the issue.

Marker does not display correct LED indicator color when turned on—

Ensure that the battery that you’re using in your new marker is a high quality alkaline 9

volt. Verify that your battery is correctly oriented (matching with the correct terminals),

and that it is making rm contact with the prongs on the circuit board. If that does not

correct the problem, verify that the breech of the maker is clear of obstructions, the bolt

is in the back position, and that the eyes are plugged into the harness.

Marker is leaking from the ASA—

Check the tank oring (015 Urethane) for nicks or tears. If this does not correct the leak,

check that the macroline hose is in good condition, and not cut unevenly.