User's Manual

w w w . B o b L o n g D i r e c t . c o m
15
Mileage Recommended Upkeep
5,000 Shots (2.5 Cases)
• Clean and regrease rammer
• Inspect o-rings for damage
• Clean debris and old grease from ram inte-
rior
10,000 Shots (5 Cases)
• Repeat above steps
• Clean, inspect, and regrease HPR Piston
and o-rings
• Clean, inspect, and regrease LPR Piston
and o-rings
20,000 Shots (10 Cases)
• Repeat above steps
• Clean, inspect, and regrease poppet shaft
o-ring
Rammer Maintenance
• De-gas the marker and insure that there
are
no paintballs in the breech or barrel of the
marker.
• Remove the ram cap from the rear of the
marker.
• Remove the bolt from the marker by pulling
upward on the bolt pin.
• Remove the ram by tilting the marker up
ward, allowing the ram to gently slide out of
the ram sleeve.
• Remove the ram from the Protege, and
clean any excess grease and debris from
the ram with a clean cloth.
• Inspect the surface of the ram and orings
for excessive wear or nicks, and replace as
necessary.
• Inspect the interior of the ram sleeve—if
necessary, use a swab on the interior of the
ram sleeve to clean debris and old grease.
• Regrease the ram with Dow 55, and gently
replace the ram back into the sleeve.
• Reinstall your Protege ram cap, and check
the marker for leaks by airing it up.
MAINTENANCE