User's Manual

w w w . B o b L o n g D i r e c t . c o m
14
European Mode
To comply with European rearm regulations, the Frenzy 3.0 board can be cong-
ured to remove the Full Auto and 3-Shot modes. To enable the European Mode:
• Turn off the marker
• Turn dipswitches 4 and 5 ON (turning the marker to full auto)
• Hold down the trigger and power on the marker (continue to hold down the trigger
even after the marker has booted); the LED will ash white once
• After the LED has ashed white, press the power button again and it will change
color
• Release the trigger, and the LED will change color again
• Pull the trigger 10 times; the marker will now power down after 3 seconds
• Turn dipswitch 3 to the ON position
• The board is now capped at 15 balls per second, and locked with European set
tings
Australian Mode (Semi-Automatic Mode Only)
• Power off board.
• Set dip switches 4 and 5 to the (On) position.
• Pull and hold trigger while powering on board.
• When LED ashes white press power button once, then LED will turn aqua.
• Release trigger and LED will turn green awaiting your response.
• Pull trigger 13 times then wait until board powers itself off.
• Set dip switches 4 and 5 back to the (Off ) position.
• When you power on your board it will be locked in Australian Mode.
• Use dip switch 3 to cap your BPS output in compliance with tournament regula
tions.