User's Manual
w w w . B o b L o n g D i r e c t . c o m
13
Dwell Setup Mode:
To check your Dwell setting:
• Flip dipswitch #6 to ON
• Power up the marker
• The LED will ash the current Dwell setting, and the
marker will power itself off. (IE: 1 ash = 1ms of Dwell)
To change your Dwell setting:
• Flip dipswitch #6 to ON
• Power up the marker.
• Pull, and hold down the trigger while powering the marker on.
• The LED will now become white; release the trigger. After releasing the trigger, the
LED will turn off, and ash the current Debounce setting, and then turn green—indi
cating that it is ready for input.
• Pull the trigger the number of times you wish to set the Debounce to (IE: 6 pulls = 6
ms of dwell), and wait.
• The board will respond by ashing the setting you just entered, conrming your set
ting.
• Return dipswitch #2 back to the OFF position, and reboot your marker.
NOTE: DO NOT ARBITRARILY CHANGE THE DWELL SETTING OF YOUR MARKER! DOING
SO CAN CAUSE ERRATIC VELOCITY READINGS AND MARKER MALFUNCTION!
1
2 3
4 5
6
1
2 3
4 5
6
1
2 3
4 5
6
1
2 3
4 5
6
1
2 3
4 5
6
3 Shot Burst
Ramping
Full Auto
Semi- Auto
All assisted ring modes (Full Auto, Ramping, 3 Shot) activate after the 3rd trigger
pull.
Firing Mode Setup:
Firing Modes are controlled through dipswitches 4 and 5. To congure them,simply
manipulate the switches to the setting you desire.