User's Manual

w w w . B o b L o n g D i r e c t . c o m
11
1
2 3
4 5
6
ON
Dipswitches control the specic electronic settings of the
marker. In the illustraton to the left, Dipswitch 1 would be
ON, and dipswitches 2-6 would be OFF.
Setting 1 2 3 4 5 6
ON
Final Tune
Cycle Delay
ON
Debounce
Setup Mode
ON
ROF Cap ON
(15 BPS)
Firing Mode
(See Below)
Firing Mode
(See Below)
Dwell Setup
Mode ON
OFF
Fine Tune
Cycle Delay
OFF
Debounce
Setup Mode
OFF
ROF Cap OFF
(Uncapped)
Firing Mode
(See Below)
Firing Mode
(See Below)
Dwell Setup
Mode OFF
Dipswitch 0peration
Debounce Setup Mode:
To check your Debounce setting:
• Flip dipswitch #2 to ON
• Power up the marker
• The LED will ash the current Debounce setting, and the
marker will power itself off. (IE: 1 ash = 1ms of Debounce)
To change your Debounce setting:
• Flip dipswitch #2 to ON
• Power up the marker.
• Pull, and hold down the trigger while powering the marker on.
• The LED will now become white; release the trigger. After releasing the trigger, the
LED will turn off, and ash the current Debounce setting, and then turn green
indicating that it is ready for your response.
• Pull the trigger the number of times you wish to set the Debounce to (IE: 6 pulls = 6
ms of Debounce), and wait.
• The board will respond by ashing the setting you just entered, conrming your set
ting.
• Return dipswitch #2 back to the OFF position, and reboot your marker.
1
2 3
4 5
6
Dipswitch Indicators