User's Manual

10
ASSEMBLY
&
DISASSEMBLY
GETTING STARTED
When disassembling the MARQ, always ensure the Marker is degassed.
The DISASSEMBLY portion of this manual will be divided into four sections.
1. FIRING ENGINE DISASSEMBLY
2. TRIGGER FRAME DISASSEMBLY
3. BODY DISASSEMBLY
4. REGULATOR DISASSEMBLY
Note
:
When ASSEMBLING the MARQ, perform the entire disassembly process in reverse order.
ASSEMBLY TIPS
When assembling the MARQ, always be sure to place a good amount of lubricant in the O
-
ring grooves before
Installing all O
-
rings and then lube O
-
rings as normal. This serves to assist in creating a proper seal and
reduces the likelihood that the Marker will leak once re
-
assembled.
When affixing the frame onto the body, be sure to hold the trigger all the way in to allow for seamless
installation.
To install and remove Trigger,the Trigger Frame must be removed from the Marker Body to allow the
Trigger to slide out through the top of the Frame.
assembly
&
disassembly
9
12
34
56
1.FIRING ENGINE
DISASSEMBLY
The Firing Engine can be accessed by
removing the retaining screw located
on the bottom of the rear plate
[
figure 1
]
and using the Allen Key,
work the assembly loose
[
figure 2
]
and then slide out the entire
assembly
[
figure 3
]
.
1. remove firing engine retaining screw
2. work loose the assembly using an allen key
3. slide out entire assembly
4. remove back block retaining screws
[
3
]
5. slide off back block from rest of assembly
6. using a pair of needle
-
nose pliers and a
1/4
”
socket driver, unscrew bolt from
bolt/ram shaft
HOT TIPS
The Bolt is firmly secured onto the Bolt/Ram
Shaft using Red Loctite from factory and must
be heated up in order to break the seal. A lighter
or heat gun can be used to do this without
damaging any of the components.