User's Manual

89
12
1110
LOW
-
PRESSURE REGULATOR
8. remove brass pressure adjuster from
regulator body
9. remove lpr main spring
10. remove regulator piston
11. remove air valve from regulator body
12. complete regulator assembly
-
see
below for assembly tips
HOT TIPS
Removal of the Main
-
Valve inside the LPR
Body may require the use of a specialized
valve tool.
W hen reassembling the Low
-
Pressure
Regulator be sure the parts are assembled
in the order shown in figure 12.
Place a small bead of blue Loctite on
the Air Valve threads during Assembly
to ensure a proper seal.
FINAL NOTES
:
Always remember to lubricate O
-
ring grooves
BEFORE installing O
-
rings to ensure a proper seal.
Use Dow55 to lubricate all O
-
rings. May be
substituted with Dow33 if necessary.
NEVER Grease Bolt. Only use OIL to lubricate Bolt.
12
34
56
7
22
assembly
&
disassembly
21
4.REGULATOR
DISASSEMBLY
HIGH
-
PRESSURE REGULATOR
1. separate regulator halves
2. loosen asa swivel adapter
set screws
[
1 on either side side
]
3. remove asa swivel adapter from
hpr upper regulator body
4. remove air valve from upper
regulatorbody
5. remove regulator adjustment screw
6. slide an allen key up through the
bottom of the lower regulator body
and push out the regulator piston
and bellville spring washer assembly
[
ensure parts do not fall as they
can become damaged
]
7. complete regulator assembly
-
see
below for assembly tips
HOT TIPS
W hen reassembling the High
-
Pressure
Regulator be sure the parts are assembled
in the order shown in figure 7.
Place a small bead of blue Loctite on
the Air Valve threads during Assembly
to ensure a proper seal.