User's Manual

assembly
&
disassembly
17
78
12 13 14
91011
7. disconnect hose from solenoid manifold
8. disconnect solenoid from wiring harness
9. remove solenoid manifold retaining screws
[
2
]
and remove solenoid from body
10. remove LPR retaining screws
[
4
]
and remove
LPR from body
11. carefully remove wiring harness from body
12. remove feedneck wedge adjustment screw
13. remove feedneck wedge
14. remove feedneck
HOT TIPS
Be sure to route the Wiring Harness correctly as the
Eye Boards are side specific and cannot be used on
either side.
W hen removing the Solenoid and LPR , be careful not
to lose the 3 small O
-
rings as they are detrimental
to the proper operation of the Marker.
For easier installation of the Feedneck Wedge, tilt the
Marker Body backwards and carefully insert wedge.
Then carefully turn in the adjustment screw into
the Wedge,
18
12
34
65
3.BODY DISASSEMBLY
1. remove eye cover retaining screws
and remove covers
[
1 on each side
]
2. remove detent springs
[
1 on each side
]
3. remove ball detents
[
1 on each side
]
4. remove eye board retaining screws
[
1 on each side
]
5. disconnect eye boards from wiring
harness
[
1 on each side
]
6. turn body over to expose solenoid
and low
-
pressure regulator
HOT TIPS
To ensure you don
’
t lose the Detents
and/or Detent Springs, always ensure
Marker is lying on it
’
s side BEFORE
removing eye covers.
When re
-
connecting the Eye Boards to
the Harness and DO NOT use excessive force
as they should connect with relative ease.
If you feel you are applying too much
pressure, inspect the parts to ensure
you are connecting the correct board
to the particular Harness lead in the
correct orientation.