User's Manual

19
CAUTIO N: READ ALL WARNINGS BEFORE USING OR ATTEMPTING ANY WORK ON
YOUR MARKER. SHOULD YOU BE UNSURE AT ANY POINT, STOP AND SEEK
PROFESSIONAL SUPPORT.
Troubleshooting Guide
Marker will not turn on out of the box
-Ensure that the battery that you’re using in your new
marker is a high quality alkaline 9 volt.
-Verify that your battery is correctly oriented (matching
with the correct terminals), and that it is making firm
contact with the prongs on the circuit board.
-Make sure that the wiring harness is correctly inserted
into the receptacle, and that the on\off pad is making
contact with the switch on the circuit board.
Velocity is inconsistent over the
chronograph
-Always check that your paintballs are of high quality,
and consistent in size, as well as using a good paint to
bore match.
-Make sure the LPR and the HPR are set to the proper
pressures.
-Replace your battery.
-Inspect the ram o-rings for nicks and that they are
properly greased
Marker is breaking paint
- Always check that your paintballs are of high quality,
and consistent in size, as well as using a good paint to
bore match.
-Make sure the HPR and the LPR are set to the proper
pressures.
-Ensure that your detents and bolt face are in good
condition, and there is no debris in the breech of the
marker.
-Reset your board settings to factory settings and use a
force-fed loader.
-Check the tension/pressure settings if you are using a
force fed loader. Having too high of a feed pressure with
fragile paint can cause balls in the stack to break