User's Manual

17
CAUTIO N: READ ALL WARNINGS BEFORE USING OR ATTEMPTING ANY WORK ON
YOUR MARKER. SHOULD YOU BE UNSURE AT ANY POINT, STOP AND SEEK
PROFESSIONAL SUPPORT.
Q&A
1. Q: My G6R is VERY bouncy and I can’t do anything! I’ve topped out the debounce and AMB
and I put the trigger in like every position possible.
A: Make sure the trigger spring is installed. Make sure the trigger activates near the end of
the pull. If necessary back out the trigger activation set screw ½ turn.
2. Q: Where can I get an o-ring kit?
A: Bob Long Technologies and authorized resellers have o-ring and parts kits available.
3. Q: What is the recommended dwell setting?
A: Dwell should be at 6 from the factory. There's no advantage to running a higher dwell to
"break it in". There are exactly zero heavy springs in the HPR or LPR that need broken in.
4. Q: I am seeing large velocity fluctuations – what should I do?
A: Check for a good paint to barrel match. Ensure the HPR spring stack is assembled
correctly and that your ram, HPR, LPR and poppet o-rings are lubed with Dow 55. Apply a
drop of blue Loctite to the threads of the LPR adjustment screw then check the regulator
pressures.
5. Q: I lowered my bolt delay and now the eyes registering an eye malfunction and lowered my
bps to 12. What should I do?
A: The bolt delay is too low at 8ms, the eyes are activating too early while the bolt is still
cycling backwards to prepare itself for the next paintball to drop. The eyes activate, see your
bolt, and never register a change from the bolt to the ball coming in place. Raising the
setting to 10 will normally clear this problem.
6. Q: So what is this bolt delay setting?
A: Bolt delay is actually an eye activation setting and not a bolt setting. Essentially you need
a delay added in so the eyes don't turn on while the bolt travels backwards after a shot. If
they turn on too soon, the marker thinks the bolt is a ball and will queue the next shot. This
causes skipped shots and occasional chops. Keep it at 10 (or higher
7. Q: What weight is the stock G6R micro switch?
A: 80g
8. Q: How much oil should I put on the bolt?
A: Just a drop on each o-ring. Put a drop on, then use your finger to put it around the entire
ring. Too much oil can cause bolt movement problems or result on oil splattering on the eye
system in extreme cases.
9. Q: What threading is the barrel?
A: Autococker
10. Q: Is the Stock trigger a roller bearing?
A: Yes