User's Manual

CAUTION: READ ALL WARNINGS BEFORE USING OR ATTEMPTING ANY WORK ON YOUR VICE.

SHOULD YOU BE UNSURE AT ANY POINT, STOP AND SEEK PROFESSIONAL SUPPORT.

MAINTAINING THE HPR

Your Vice comes equipped w i th t he be st regulators on the market. To ensure the best consistency and the highest

flow possible, it is recommended that you clean and grease the in line regulator ( H P R ) according to the

maintenance schedule.

1. Degas the marker and ensure that there are no

paintballs in the breech or barrel of the marker.

2. Remove your macroline hose from the 90˚

fitting on your regulator. Push up on the hose

then hold the silver ring while pulling the hose

down.

3. Unscrew the regulator from the vertical

adaptor, and set your marker down.

4. Grasp the two halves of the regulator, and

unscrew the regulator base counter clockwise.

5. Reach into the regulator base with tweezers or

needle nose pliers to remove the regulator

piston.

6. The main valve does not need to be removed

f r o m t h e upper portion of the regulator. Never

replace or attempt to service a working main

valve.

7. Inspect the surface of the piston and pi ston o-

ring for excessive wear or nicks, and replace as

necessary.

8. Inspect the interior walls of the regulator base—

if necessary, use a swab on the interior of the

regulator base to clean debris and old grease.

9. When reas se m bl i ng the spring follower (spring

stack assembly) make sure that the top and

bottom spring washers curve to the outside. A

close up of the spring assembly with the

retaining o-ring is shown to the right. The

retaining o-ring does not require lubrication

If in doubt – just stack the spring washers like

this:

)()()()(

10. Grease the piston o-ring with a nd g e n tly replace

the spring follower (spring stack assembly) a nd

piston into the regulator base. There is a

concave area around the o-ring that holds

additional lube and reduces the need for

frequent maintenance. Reassemble the

regulator to the marker. Make sure the

regulator body halves and the regulator itself

are snugly screwed together.