User's Manual

CAUTION: READ ALL WARNINGS BEFORE USING OR ATTEMPTING ANY WORK ON YOUR VICE.
SHOULD YOU BE UNSURE AT ANY POINT, STOP AND SEEK PROFESSIONAL SUPPORT.
ADJUSTING THE TRIGGER
The Gen 5 Intimidator trigger has two adjustment screws. The bottom
screw is for trigger post-travel and the top screw adjusts the activation
point (where the marker fires). To adjust the screws insert a hex key
and turn the screw. The screws have Loctite to prevent the
adjustment from slipping so a firm, steady pressure is needed for the
adjustment.
REPLACING/UPGRADING
The stock trigger is similar to the S-class trigger. However, the stock
trigger does not have a roller bearing. To replace the trigger with an S-
class trigger remove the grip frame then remove the retaining screw
from the left side of the grip frame.
The trigger can be removed and a replacement inserted. Make sure to
install the spring on the new trigger. The S-class trigger has a new pivot
screw and a spacer, which goes between the trigger and the right side of
the grip frame. The spacer is shown in th e pi c t ur e b el o w.