User's Manual

CAUTION: READ ALL WARNINGS BEFORE USING OR ATTEMPTING ANY WORK ON YOUR VICE.
SHOULD YOU BE UNSURE AT ANY POINT, STOP AND SEEK PROFESSIONAL SUPPORT.
QUICK START
INSTALLING AIR TANK
Much like any other tournament marker, the Vice requires the use of compressed air or nitrogen only. The Vice is
compatible with both high-pressure and low pressure compressed air systems. If using an adjustable-output air
system, set the system’s output between 450 and 550 psi. Screwing your preset air system into the ASA at the
bottom of the grip will pressurize the marker, preparing it for use.
TURNING MARKER ON/OFF
To power on the marker: press and release the power button.
To power the marker off: press and hold the power button for 1.5
seconds, until the LED turns off, then release.
ADJUSTING VELOCITY
Although both of the regulators on the Vice come preset from the factory, y ou ma y n ee d t o adjust the regulators
to account for paint to bore match, atmospheric differences, and your
field’s maximum chronograph limit. The velocity of your marker is
controlled through the vertical regulator, which is adjusted with a 1\8”
Allen wrench. Turning the screw clockwise (or inward) will increase
your velocity; turning the screw counterclockwise will decrease your
velocity. Only turn the wrench 1/8
th
-1/16
th
of a turn with each
adjustment.
TURNING EYES ON/OFF
Briefly press and release the power button when the marker is turned on to disable the eyes. Briefly touch it a
second time to re-enable the eyes. Each time the marker is turned on the eyes are enabled regardless of whether
they were enabled when the marker was shut off.
For early releases of the Protégé which incorporated the Frenzy 3.0 board consult the control board manual on
w ww . b ob lo n g di r ec t. c om for eye operation.