User's Manual

CAUTION: READ ALL WARNINGS BEFORE USING OR ATTEMPTING ANY WORK ON YOUR VICE.
SHOULD YOU BE UNSURE AT ANY POINT, STOP AND SEEK PROFESSIONAL SUPPORT.
Air is leaking from the rear of the marker
f r am e
-Remove the trigger frame from the marker, and inspect the hose
to the solenoid. If it appears worn or pinched, consider replacing
the hose.
-If your marker has this excessive compression of the hose
replace the hose and apply a small amount of grease to the hose
to allow it to compress in the frame without being deformed. If
this does not fix your issue, consult expert advice or seek
professional repair
Marker leaks down the barrel
-Ensure that your ram o-rings are free of nicks, and properly
lubricated.
-Verify that your poppet s e al is in good condition, with its sh af t o-
ring i s fre e of nicks and properly lubricated.
-If this does not correct your issue, consult expert advice or seek
professional repair
Marker fires more than one shot per pull, or
has trigger bounce
- Verify that your trigger has the spring installed and th a t i t i s
properly seated
- Verify that your marker is in semi-automatic mode
- Raise your marker’s debounce level, and make sure that your
trigger activation level is not too short.
Marker double feeds
-Verify that detent springs are in place and detents move freely
-Replace the marker’s ball detents if they are excessively worn
-If using Super Ds make sure the detents are lubricated on the
sides