User's Manual

CAUTION: READ ALL WARNINGS BEFORE USING OR ATTEMPTING ANY WORK ON YOUR VICE.
SHOULD YOU BE UNSURE AT ANY POINT, STOP AND SEEK PROFESSIONAL SUPPORT.
TROUBLESHOOTING GUIDE
Marker will not turn on out of the box
-Ensure that the battery that you’re using in your new marker is a
high quality alkaline 9 volt.
-Verify that your battery is correctly oriented (matching with the
correct terminals), and that it is making firm contact with the
prongs on the circuit board.
-Make sure that the wiring harness is correctly inserted into the
receptacle, and that the on\off pad is making contact with the
switch on the circuit board.
Velocity is inconsistent over the chronograph
-Always check that your paintballs are of high quality, and
consistent in size, as well as using a good paint to bore match.
-Make sure the LPR and the HPR are set to the proper pressures.
-Replace your battery.
-Inspect the ram o-rings for nicks and that they are properly
greased
Marker is breaking paint
- Always check that your paintballs are of high quality, and
consistent in size, as well as using a good paint to bore match.
-Make sure the LPR and the HPR are set to the proper pressures.
-Ensure that your detents and bolt face are in good condition, and
there is no debris in the breech of the marker.
-Reset your board settings to factory settings and use a force-f e d
loader.
-Check the tension/pressure settings if you are using a force fed
loader. Having too high of a feed pressure with fragile paint can
cause balls in the stack to break
Marker does not gas up after tank is
connected
-Verify that the pin valve on your tank is outputting pressure to
the regulator—some tanks will not work properly with certain
ASAs.
-Attempt gassing up the marker with another tank to see if this
remedies the issue.
Marker does not display correct LED indicator
c ol o r w he n tu rn e d o n
-Verify that your battery is correctly oriented (matching with the
correct terminals), and that it is making firm contact with the
prongs on the circuit board.
-Verify that the breech of the maker is clear of obstructions, the
bolt is in the back position, and that the eyes are clean and
plugged into the harness.
Marker is leaking from the ASA
-Check the tank o-ring (015 Urethane D90) for nicks or tears.
-Check that the macroline hose is in good condition and is cut
evenly
- The macroline fitting has a 010 o-ring. Remove the fitting and
replace the o-ring if the above does not correct the problem
Marker is leaking from the HPR
-If the leak is coming from the macroline elbow, make sure that
the macroline fitting has been secured to the regulator with
f ac t o ry ap pr o ve d t hr e ad -sealant (NOT TEFLON TAPE)
- Check that the macroline hose is in good condition and is cut
evenly
-Replace the piston o-ring inside the regulator.
Air is leaking from the front of the marker
f r am e
-Verify that the racetrack o-ring in the front of the frame is free of
nicks and has a light coat of grease to induce swelling.
-Verify that the screw in the center of the vertical ASA is snug and
that nothing obstructing t he frame from making a tight seal with
the bottom of the body.