User's Manual

CAUTION: READ ALL WARNINGS BEFORE USING OR ATTEMPTING ANY WORK ON YOUR VICE.

SHOULD YOU BE UNSURE AT ANY POINT, STOP AND SEEK PROFESSIONAL SUPPORT.

Q&A

1. Q: My Vice is VERY bouncy and I can’t do anything! I’ve topped out the debounce and AMB and I put the

trigger in like every position possible. W o ul d it be the loader delay help any? What else should I do?

A: Make sure the trigger spring is installed. Make sur e the trigger activates near the end of the pull. If

necessary back out the trigger activation set screw ½ turn.

2. Q: Where can I get an o-ring kit?

A: Bob Long Technologies and authorized resellers have o-ring and parts kits available.

3. Q: What is the recommended dwell setting?

A: Dwell should be at 6 when you get the marker and after you use it. There's no advantage to running a

higher dwell to "break it in". There are exactly zero heavy springs in the HPR or LPR that need broken in.

4. Q: What pressure should my LPR be set to with the LPR tester?

A: The Upgraded Low Pressure Poppet around 65-70. The stock poppet should enable you to run the LPR

around 70-7 5 .

5. Q: I am seeing large velocity fluctuations – what should I do?

A: Check for a good paint to barrel match. Ensure the HPR shim stack is assembled correctly and that your

ram, LPR, HPR and poppet o -rings are lubed with Dow 55. Check the LPR pressure and apply a drop of

blue Loctite to the threads of the LPR adjustment screw.

6. Q: I l owe r ed m y b ol t d e la y and now the eyes registering an eye malfunction and lowered my bps to 12.

What should I do?

A: The bolt delay is too low at 8ms, the eyes are activating too early while the bolt is still cycling

backwards to prepare itself for the next paintball to drop. The eyes activate, see your bolt, and never

this problem.

7. Q: So what is this bolt delay setting?

A: Bolt delay is actually an eye activation setting and not a bolt setting. Essentially you need a delay added

in so the eyes don't turn on as the bolt is on it's backward travel. If they turn on too soon, the marker

thinks the bolt is a ball and will queue up the next shot. This causes skipped shots and of te n c h op s . Ke e p i t

at 10 (or higher)...because your board isn't seeing a gap between when the bolt cycles and the ball drops

and thinks the eyes are malfunctioning.

8. Q: What weight is the stock vice micro switch?

A: 80g

9. Q: How much oil should I put on the bolt?

A: Just a drop on each o-ring. Put a drop on, then use your finger to put it around the entire ring. Too

much oil can cause bolt movement problems or result on oil splattering on the eye system in extreme

cases.

10. Q: What threading is the barrel?

A: Autococker